The 2015 Camry oil filter location and part number

The oil filter on a 2015 Toyota Camry sits on the driver's side of the engine, below the intake manifold and behind the engine block. You'll access it from underneath the vehicle or from the side, depending on whether your Camry is a sedan or hybrid model. The filter is a cylindrical cartridge about 3 inches tall, mounted vertically with the threaded cap facing down.

Toyota part number 90915-YZZA1 is the OEM (original equipment manufacturer) filter for all 2015 Camry models, including the hybrid. This part number appears on Toyota dealership invoices and on many aftermarket retailer websites. If you order by this number, you'll receive the correct filter regardless of which retailer you use.

The filter costs between $8 and $15 at most retailers. Dealerships typically charge $12 to $18 for the same part. You do not need a special filter for the hybrid model — the same part fits both the standard gasoline engine and the hybrid powertrain.

Key Takeaways

  • The 2015 Camry oil filter is located on the driver's side of the engine, accessed from below or the side depending on your model.
  • Toyota part number 90915-YZZA1 is the correct filter for all 2015 Camry models, including hybrids.
  • You will need an oil filter wrench (a socket-style tool that grips the filter canister) and a drain pan to catch old oil during removal.
  • The filter should be replaced every 10,000 miles or as recommended in your owner's manual maintenance schedule.

Tools and supplies you'll need

Before you start, gather an oil filter wrench, a drain pan, and fresh oil. The wrench is the most important tool — it's a socket-shaped device that grips the cylindrical filter so you can turn it without your hands slipping. Filter wrenches cost $8 to $20 and fit filters of different sizes; the 2015 Camry filter works with most standard wrenches sized for 3-inch filters.

You'll also need a drain pan large enough to hold at least 5 quarts of oil (the old filter contains roughly half a quart). A shallow metal or plastic pan works fine. Have rags or paper towels nearby to wipe your hands and catch drips around the filter housing.

If you're replacing the oil at the same time, you'll need the correct oil type and quantity for your Camry. Check your owner's manual or the oil cap under the hood for the specification — most 2015 Camrys use 0W-20 synthetic or conventional oil, and the engine holds about 4.5 quarts with a filter change.

How to remove the old filter

Start with the engine cold and the vehicle on a level surface. Raise the front of the car with a jack if you need more clearance to reach the filter from below, or work from the side if your Camry is a sedan with easier access. Place your drain pan underneath the filter to catch any oil that spills when you loosen it.

Fit the oil filter wrench over the filter canister and turn counterclockwise by hand. The filter will loosen after a quarter turn or so. Once it's loose enough, unscrew it the rest of the way by hand, turning slowly to avoid spilling oil on the engine block. As the filter comes free, tip it slightly so any remaining oil drains into the pan.

Before you install the new filter, wipe the filter mounting surface (the threaded boss on the engine) with a clean rag to remove any dirt or old oil residue. This ensures a good seal and prevents leaks.

Installing the new filter correctly

Take the new filter and explore a thin layer of fresh oil to the rubber gasket (the flat ring around the top of the filter). This helps the gasket seal properly and makes removal easier next time. Do not over-oil the gasket — a light coat is all you need.

Screw the new filter onto the threaded boss by hand. Turn it clockwise until the gasket contacts the mounting surface, then turn an additional three-quarter turn. Do not use the filter wrench to tighten — hand-tight is correct. Over-tightening can damage the gasket and cause leaks.

Start the engine and let it run for 30 seconds to circulate new oil through the filter. Turn off the engine and wait two minutes, then check the oil level on the dipstick. Add oil if needed to bring the level to the full mark. Check under the car for any drips around the filter — if you see oil leaking, the filter may not be seated correctly and you'll need to tighten it slightly more.

When to replace the filter

Toyota recommends replacing the oil filter every 10,000 miles for 2015 Camrys, or every 12 months, whichever comes first. If you drive mostly on highways at steady speeds, you may go the full 10,000 miles. If you make frequent short trips or tow a trailer, replace it sooner — every 5,000 to 7,500 miles is common for these driving patterns.

Your maintenance schedule in the owner's manual will specify the exact interval for your driving conditions. Most owners find it easiest to replace the filter every time they change the oil, which keeps the schedule straightforward and ensures the filter never gets too old.

Where to buy the correct filter

You can order the 90915-YZZA1 filter from Toyota dealerships, chain auto parts retailers (AutoZone, O'Reilly, NAPA, Advance Auto Parts), online marketplaces, and warehouse clubs like Costco. Dealerships stock it in-house and can usually have it ready the same day. Chain retailers typically have it in stock or can order it for next-day pickup.

Online retailers often have lower prices but charge shipping unless you meet a minimum order. Warehouse clubs sometimes offer the filter at a discount if you have a membership. Compare prices across two or three sources before ordering — the difference between the cheapest and most expensive option is usually $5 to $7.

Aftermarket filters from brands like Fram, Bosch, and Mobil 1 also fit the 2015 Camry and cost slightly less than the OEM Toyota filter. These filters meet the same performance standards and are safe to use, though some owners prefer the OEM part for peace of mind.

Frequently Asked Questions

Can I use a different oil filter size on my 2015 Camry?

No. The 2015 Camry is designed for the 90915-YZZA1 filter size and thread pattern. Using a different size can cause leaks, improper oil flow, or damage to the engine. Always confirm the part number before you order.

What should I do with the old filter after I remove it?

The old filter contains used oil and should be recycled, not thrown in the trash. Most auto parts retailers accept used filters for free if you buy a new one from them. Some recycling centers and municipal hazardous waste facilities also take them. Drain as much oil as possible into your pan before dropping it off.

Is the filter location the same on a 2015 Camry hybrid?

Yes. The hybrid model uses the same filter in the same location as the standard gasoline Camry. The part number and replacement procedure are identical.

How tight should I turn the new filter by hand?

Turn it until the rubber gasket touches the mounting surface, then turn an additional three-quarter turn. This is snug enough to seal but not so tight that you'll struggle to remove it next time. If you use a wrench to tighten it, you've gone too far.

Will my check engine light come on after I replace the filter?

No. Replacing the oil filter does not trigger the check engine light. If the light comes on after a filter change, it's unrelated to the filter itself — check your oil level and have the engine scanned for fault codes.